Cut List Calculator

Paste one length × quantity per line, choose stock length and kerf, then inspect a browser-local first-fit stock estimate and cut summary.

Cut lengths, kerf & stock estimate

Enter one length × quantity per line. Lengths may use feet/inches, inches, mm, cm or meters.

Cut list

Stock length (ft)

Saw kerf (in)

Extra waste (%)

Price per stock piece ($)

—Total cuts

—Cut length

—Approx. stock pieces

—Optional cost

Stock piece	Cuts	Remaining

The stock count uses a simple first-fit-decreasing estimate. Grain direction, defects, required end trimming, cut order, blade setup and optimization constraints are not modeled.

Construction Calculator Feet & Inches Square Footage Linear Feet Cut List Rafter Concrete

Linear stock utilization audit

Cross-check cuts, kerf, stock count, utilization, waste and remaining material.

Shop evidence

Board	Used	Leftover	Utilization

Field measurement & procurement tolerance audit

Rebuild the visible project math independently, then perturb the field measurements to expose a min/base/max envelope before cutting or ordering. This is a planning cross-check, not structural engineering, code approval, or supplier certification.

Measurement toleranceTolerance basisInterpretation

Refresh the field audit after entering project measurements above.

Browser-local planning cross-check. Verify final dimensions on site before cutting or ordering.

Construction field-work cluster

Carry measurement uncertainty into the material decision

Use the exact calculator first, then stress-test realistic field measurement and rounding tolerance before a cut or purchase. Keep structural design, code approval and supplier specifications outside the browser estimate.

Start: Construction Calculator Check Area

All 30 construction tools

RafterSpan, pitch, board length and field tolerance Roof PitchRise/run, angle, factor and measurement sensitivity BrickOpenings, waste, modules and order sensitivity Cubic YardsVolume, waste, delivery and tolerance envelope Feet & InchesTape arithmetic, fraction rounding and tolerance Cut ListCut lengths, kerf, stock and tolerance GravelDepth, density, tonnage and order sensitivity StairsRise/run geometry and field-measurement sensitivity

Planning notes

Start with the measurement this calculator asks for, then use related length, area/volume, roof, stair, material, waste, or cut-planning tools only when the job needs them. Inputs and results stay in the browser.